You are here:   Home  > Ericsson > A1018S > Inside A1018S > C-description 

 

 

 

 


  1. GSM de/modulator with Atmel based 32 bit AVR microcontroller and embedded SRAM
  2. Intel Flash TE28F800 = 512kx16 used as program memory. Max 1Mx16 allowed.
  3. Atmel serial (I2C) EEProm 24C64
  4. Ericsson DSP
  5. Bottom connector
  6. X-tal oscillator (32.768kHz)
  7. SIM card reader
  8. SIM card connector
  9. Audio codec (A2D, D2A, PCM).
  10. Voltage controlled oscillator for RX DCS frequency
  11. Voltage controlled oscillator for RX GSM frequency
  12. 13MHz x-tal, can be electronically trimmed by varistor
  13. Ericsson transceiver IC: mixer, IF (Homeros)
  14. Low pass filter 1842MHz
  15. Murata, 1842.5MHz bandpass filter
  16. Antenna source switch
  17. Antenna connector
  18. Hitachi Power amplifier PF08105
  19. Power management unit
  20. Murata, SAW bandpass filter 947.5MHz
  21. Murata Balun (Tx)
  22. Murata
  23. National Semiconductor: LP2988: 200 mA Ultra Low-Dropout Low Noise Voltage Regulator with Programmable Power-On Reset Delay
  24. PLL

    All 6 pins white ceramic components, e.g. the one below 16, are baluns.

[Alcatel] [Bosch] [Ericsson] [Motorola] [Nokia] [Panasonic] [Philips] [Sagem] [Siemens] [Sony] [Base stations] [Extras] [Miscellaneous]

Page last updated: 24/12/02  

 

   

     

 

 

 

Hosted by uCoz